How do I adjust a rusted bicycle seat post? - bicycle shaped invitations
My friend has my old machine for her daughter's daughter, which was omitted. The bike is in good condition, except that I have not been able to adjust the seat height, that the body appears rusted in place. Suggestions on how you move it?
Monday, December 7, 2009
Bicycle Shaped Invitations How Do I Adjust A Rusted Bicycle Seat Post?
Subscribe to:
Post Comments (Atom)
5 comments:
WD-40 should. You can also use a wrench to loosen further.
WD-40 should. You can also use a wrench to loosen further.
When WD-solving rather than the 40, try some automatic transmission fluid. Do not laugh, that it is a highly penetrating oil. Take your time and you never have to use penetrating oil soak, if you want to reduce overnight on their efforts and damage parts of bicycles.
The screw in, sprinkle with the position of WD40 or product removal from, to assist the parties to release, this section to the extent of frame content. Let stand for a while. Try to get loose in the seat for a lever. Try to contact you. If this fails, press the point with a hammer. To work with a piece of scrap wood or not Dent - a rubber mallet. If this fails, a last resort (I assume that only a bicycle for children) cheap Take a big flathead screwdriver and insert it into the slot in the upper back is the head tube. Twist the throat of the widest point. Several times WD40. This will break the rust seal.
If you leave your job and clean with steel wool dipped in oil. Wipe on the seatpost. Apply a light grease to repeat the post-moderation, to do this. You should be ready to proceed.
Remove the screws. WD-40 or a key fluid. Let stand. and recovered from his male Mussler.
Post a Comment